ADTRAN IPR-S1000 Manuel d'utilisateur télécharger pdf (Page 84)

Configuring the IPR-S1000

the interface that one listens to.

quick: Allows to have a reduced display (minimum of essential information).

timeout: Maximum duration of the capture (in second).

timestamp: Displays time information on each packet (time is specific to the

equipment).

verbose: Defines a level of smoothness of analysis. The more the level is

raised, the more the analysis is fine.

lastprofile

Prints the last loaded profile (followed by a «*» if modified).

list

Lists all available profiles.

load + name of the profile

Loads a profile.

loadfactory

Loads the factory profile.

Lists all available profiles.

mget ATTR1 ATTR2 ...

Retrieves multiple attribute values. Pressing Tab after «get» will

display all the available attributes (see part C: sections and attributes).

They will be summed up in the next section.

mv + former_name new_name

Allows to rename a profile.

nat (Network address translation)

Displays NAT informations.

stat: Provides statistics relating to address translation.

netstat (Network statistics)

Getting network statistics.

arp (address resolution protocol): Protocol allowing to connect an IP address

and an Ethernet address.

iface: Statistics per interface.

proto: Statistics per protocol.

route: Routing table.

ping

Sends ICMP ECHO_REQUEST packets to network hosts.

count: The number of ECHO_REQUEST.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 107 108

Pas de commentaire

ADTRAN IPR-S1000 Manuel d'utilisateur Page 84