ADTRAN TSU LT Manuel d'utilisateur télécharger pdf (Page 25)

TSU LT 220V User Manual Chapter 3 Operation

Figure 3-3. TSU LT 220V Main Menus

Status

Use the STATUS menu to view the operational status of the TSU LT 220V. (Also see Status Menu on

page 31.) This menu includes the following submenus:

Config (Configuration)

Use the CONFIG menu to set the TSU LT 220V operational configuration. (Also see Config Menu on

page 35.) This menu includes the following submenus:

1) NI PERF RPTS

1) STATUS 2) CURR ERR/ALM

3) ERR/ALM HIST

1) NETWORK (NI)

TSU LT 220V Main

Menus

2) CONFIG 2) UNIT

3) PORT 1) SOFTWARE REV

3) UTIL 2) REINIT UNIT

3) ADDRESS

1) NETWORK TESTS 4) SET PASSCODE

4) TEST 2) RUN SELFTEST 5) KEYPAD

3) PORT TESTS 6) FACT RESTORE

NI PERF RPTS

Use to view and reset the user set of data on the Network Interface Performance

Reports. These reports are in compliance with ANSI T1.403 and AT&T

document TR54016.

CURR ERR/ALM Use to view current errors and alarms as reported by the TSU LT 220V.

ERR/ALM HIST

Use to view and clear the history of errors and alarms.

NETWORK (NI)

Use to set all of the parameters associated with the network interface.

UNIT

Use to control the TSU LT 220V control-port baud rate and to set up the

dial-out function.

PORT

Use to configure the parameters associated with the DTE (V.35) port.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 59 60

Pas de commentaire

ADTRAN TSU LT Manuel d'utilisateur Page 25