ADTRAN NetVanta 3205 Guide d'installation télécharger pdf (Page 41)

NetVanta 3000 Series Routers Hardware Installation Guide

Installing Dial Backup and Network Interface Modules

The DIMs plug on to the NIMs. The NIMs are then installed in the rear panel option module slot. The

following tables list the installation steps. Also see Figure 19 on page 42.

Figure 18. Installing DIMs

Always remove power from the unit prior to removing or installing a module.

Improper installation may result in damage to the modules.

Instructions for Installing the DIMs

Step Action

1. Remove power from the unit.

2. If the NIM is already in the NetVanta chassis, release the pins at both edges of the NIM

faceplate and slide the module out of the chassis.

3. Carefully align the P1 connector on the NIM with the J1 connector on the DIM. Using only

fingertip pressure so that neither circuit board bends or flexes, ensure that the connectors are

firmly seated. Secure the DIM to the NIM using the screws and standoff posts supplied. See

Figure 18.

4. Slide the NIM with the DIM attached into the NetVanta chassis, continuing with the normal NIM

installation (see Instructions for Installing the NIMs on page 42).

WAN-T1

DBU

NOTE: OPTIONAL MODULE

REQUIRED FOR DBU

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 51 52

Pas de commentaire

ADTRAN NetVanta 3205 Guide d'installation Page 41