ADTRAN TRACER 6000 SERIES Guide de dépannage télécharger pdf (Page 93)

DLP-2 Logging into the TRACER 64x0

Introduction

Once you are connected to the TRACER 64x0, you must log into the system to gain access to the

management and provisioning functions. This DLP assumes you are connected to the TRACER 64x0 and

provides specific steps for logging into the system.

Prerequisite Procedures

Complete DLP-1, Connecting a VT100 Terminal or PC to the CRAFT Port, on page 91.

see

To prevent electrical shock, do not install equipment in a wet location or during a

lightning storm.

Electronic equipment can be damaged by static electrical discharge. Before handling it,

put on an antistatic discharge wrist strap to prevent damage to electronic components.

Place equipment in antistatic packing material when transporting or storing. When

working on equipment, always place it on an approved antistatic mat that is electrically

grounded.

After the IP parameters have been provisioned (see DLP-3, Setting IP Parameters for the

TRACER 64x0, on page 95), you can also log in via Telnet.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 131 132

Pas de commentaire

ADTRAN TRACER 6000 SERIES Guide de dépannage Page 93