ADTRAN 6330 Manuel d'utilisateur télécharger pdf

Quick Start Guide, 61700120G1-13A, March 2009 1

NETVANTA 6330 SERIES

P/N 47006332G1, 47006334G1, 47006336G1, 47006337G1

GETTING STARTED

Two configuration methods are available for your NetVanta 6330 Series units:

• Web-based graphical user interface (GUI)

• AOS command line interface (CLI)

The GUI lets you configure the main unit settings and provides online guidance and explanations

for each setting. However, using the AOS CLI may be necessary for more advanced

configurations.

ACCESS THE GUI

You can access the GUI from any Web browser on your network by following these steps:

1. Connect the unit to your PC using the ETH 0/1 Ethernet port on the rear of the unit.

2. Set your PC to obtain an IP address automatically via Dynamic Host Configuration Protocol

(DHCP), or change your PC to a fixed IP address of 10.10.10.2. If you cannot change the

PC’s IP address, you will need to change the unit’s IP address using the CLI. (Refer to the

next two sections for instructions.)

3. Enter the unit’s IP address in your browser address line. The default IP address is

10.10.10.1.

4. You will then be prompted for the user name and password (the default settings are admin

and password).

5. The initial GUI screen appears.

ACCESS THE CLI

Access the AOS CLI via the CONSOLE port or a Telnet session. To establish a connection to the

NetVanta unit’s CONSOLE port, you need the following items:

• VT100 terminal or PC (with VT100 terminal emulation software)

• Straight-through serial cable with a DB-9 (male) connector on one end and the appropriate

interface for your terminal or PC communication port on the other end

1. Connect the DB-9 (male) connector of your serial cable to the CONSOLE port on the rear

panel of the unit.

2. Connect the other end of the serial cable to the terminal or PC.

3. Insert the connector of the provided power cord into the power interface on the rear panel of

the unit, and plug the cord into a standard electrical outlet.

4. Once the unit is powered up, open a VT100 terminal session using the following settings:

9600 baud, 8 data bits, no parity bits, and 1 stop bit. Press <Enter> to activate the AOS CLI.

5. Enter enable at the > prompt. Enter the enable password when prompted. The default

password is password.

CONFIGURE YOUR APPLICATION

More detailed documentation for configuring your ADTRAN unit is provided on the AOS

Documentation CD included in your shipment. For more detail on hardware setup, refer to the

appropriate NIM quick start guides and the hardware installation guide. For more detail on

configuring your system, refer to the AOS Command Reference Guide, configuration guides, and

technical support notes.

1 2 3 4

Résumé du contenu

Page 1 - NETVANTA 6330 SERIES

Page 2 - CONSOLE PINOUTS

Page 3

Page 4

Commentaires sur ces manuels

Pas de commentaire

ADTRAN 6330 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Mise en réseau ADTRAN 6330. NetVanta 6330 Series Quick Start Guide Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau ADTRAN 6330