ADTRAN Stub Routing Manuel d'utilisateur

Lab 4.9.1 Configuring ISDN BRI Objective In this lab, the student will configure two Cisco routers for DDR using ISDN BRI. The student will also co

Step 2 In global configuration mode on SanJose1, use the following to configure the username and password information for the remote router and an ena

Sa nJose1(config-if)#dialer idle-timeout 60 Next, configure the DDR setting on the BRI interface. Use the dialer-group 1 command as follows, to asso

The debug isdn q921 command may also be used to troubleshoot Layer 2 issues between the router and the ISDN switch. Once connectivity to the ISDN sw

Idle timer (120 secs), Fast idle timer (20 secs) Wait for carrier (30 secs), Re-enable (15 secs) Dialer state is idle 4. What is the idle timer set

Finally, because PPP with CHAP authentication is being used, also debug PPP as follows: SanJose1#debug ppp authentication SanJose1#debug ppp negotiat

Out 5551000 SanJose1 18 44 15 0 ---------------------------------------------------------------------