ADTRAN QDFR Unit Manuel d'installation télécharger pdf (Page 21)

Menu Descriptions

61181307L7-5E 13

Test Jack Configuration Screen

The Test Jack Configuration screen (Figure 11) controls the test jack, which is found on the

back of the QDFR unit. This jack can “look at” a chosen port, in either direction as chosen by

the user, as if it were a monitor jack (non-intrusive mode) or it can “break” a chosen port, in

either direction, as if it were a equipment jack (intrusive mode).

Figure 11. Test Jack Configuration Screen

The options on this screen are as follows:

• Toggle Test Jack Mode – Select Monitor (non-intrusive) or Terminate (intrusive)

• Change Test Port Number – Select an active port

• Toggle Inclusive Test Direction – This option has no effect on Monitor mode. Select Network

or Customer

Refer to “Appendix B”, “Rear Panel DS1 Test Access” for a full description of the function-

ality of the test jack.

Shelf: 1 Slot: 2 Total Access System mm/dd/yy hh:mm

Test Jack Configuration Screen

-----------------------------------------------------

Test Jack Mode: Monitor

Active Port Number: Port 1

Intrusive Test Direction: Network

1. Toggle Test Jack Mode

2. Change Test Port Number

3. Toggle Intrusive Test Direction

Selection:

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 47 48

Pas de commentaire

ADTRAN QDFR Unit Manuel d'installation Page 21