Adtran 600 Series Manuel d'utilisateur télécharger pdf (Page 40)

Total Access 600 Series SHDSL IAD User Interface Guide/64200683L1-31B

Page 40

RIP

Use this menu to enable RIP on the WAN interface. (See RIP on page 37 for description of options.)

RFC 1483 Bridge

This is used to enable bridge mode on this PVC. (These settings only take effect when RFC 1483 is the

selected protocol.)

PPPoATM

The Total Access 600 uses the PPPoATM profile to specify the profile used when connected using PPP.

Authentication

The authentication menu contains the required parameters for the authentication of the PPP peer and for

being authenticated by the PPP peer. Authentication is applied between the Total Access 600 and the

PPP peer as follows:

TX Method

This parameter specifies how the Total Access 600 is to be authenticated by the PPP peer. There are four

possible selections.

RIVATE

DDRESS

ODE

The private IP address can be specified to steer

certain protocols and ports to specific servers in

the private network. Likewise, internal hosts can

be steered to certain servers on the public

network. A new request from the public network

matching this entry’s public parameters will be

dropped if this mode is set to $

,

17(51$/

RIVATE

ORT

ODE



The private destination port associated with this

entry can be specified to add more control over

certain types of traffic. Leave as $

3

257

cover all port types.

RANSLATE

ODY



By default, the application payload in the packet

is scanned for occurrences of the private/public IP

address in binary or ASCII form. Set this to

for

applications where this will cause problems.

NAT V

IEW

Shows the protocols that are actively being translated.

NAPT ADDRESS

Represents the public address that is being used as the

NAPT address.

NTRY

OUNT

The number of entries in the NAT table.

NTRY

VERFLOW

OUNT

A count of the dropped entries due to low memory.

ONE

(def) The connection will not allow the PPP peer to authen-

ticate it.

, C

HAP

The connection can be authenticated using PAP,

CHAP or EAP.

HAP

The connection can be authenticated using CHAP or

EAP only.

The connection will only allow authentication by the

peer using EAP.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 71 72

Commentaires sur ces manuels

Pas de commentaire

Adtran 600 Series Manuel d'utilisateur Page 40

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Adtran 600 Series